APPLIANCE REPAIR NEW YORK

With Viking, you can have professional-quality refrigeration systems in the comfort of your very own home. It makes good sense that you would not want to trust your financial investment to just any device repair service firm. That’s why you must call the Viking fridge repair specialists.

We offer exceptional Viking refrigerator repair service seven days a week. Our specialists are on call everywhere near your location. When you need superior support for your costs fridge, call us.

The control device of your Viking refrigerator keeps an eye on the essential components of the unit. If a fault is discovered, the digital screen presents a mistake code to help find and also repair the concern.

The first step to fixing any kind of issue is to validate the error is genuine. To verify an error code, you will require to reboot the refrigerator.

To reboot your refrigerator:

Disconnect the refrigerator from the wall surface or turn off power to the outlet at the breaker.
Wait five minutes.
Return power to the refrigerator.

If the error code returns, it is a reputable mistake. Refer to the adhering to chart for more troubleshooting aid.

Error Code Discovery

The microprocessor in the control consistently monitors important refrigeration system parts for appropriate procedure. If component criteria surpass normal operating specifications, an audible alarm will certainly seem six (6) times every min and also the screen will automatically flash the particular mistake code. If several errors are kept in mind with the system, the mistake codes will certainly be shown sequentially.

Warning Alarm

The Tru Protect ™ system will certainly inform you if the system is not functioning properly. It offers both aesthetic and also distinct alerts if the temperature level rises above or falls listed below the set temperature level, if there is a power failing, or if the door is left ajar.

1. Door Ajar: If the door is left open for greater than 5 (5) mins, an audible alarm will certainly sound three (3) times every 30 secs and also the LED light will certainly flash green. This will stop as quickly as the door is closed.
2. High and Low Temperature: If the unit reaches a temperature level either above or below the set point temperature level for greater than one (1) hour, a distinct alarm will certainly seem 6 (6) times every minute as well as the LED will certainly blink red. This will certainly continue up until the alarm system is reset. The alarm might occur when altering set-points in excess of 10 levels F and/or high use which is typical.
3. Power Failing: If the unit experiences a power failure, the LED will flash brownish-yellow. This will certainly proceed up until the alarm system is reset. With a power failing, no audible signal is listened to. The alarm may occur upon preliminary setup which is typical because the device was run at the factory to validate top quality.

Resetting the Alarms

Close door to reset Door Ajar alarm. Press the “ON/OFF” button for about one (1) 2nd to reset all other audible and show alarms.

KEEP IN MIND: Although pressing the “ON/OFF” button will reset the alarms, the alarm system will certainly return to if the “alarm system problem” still exists.

Solution Diagnostics Mode
Service Diagnostics Setting permits you to identify the firmware as well as software variations, test condition of “version certain” system parts and also sensors, and also transform state of elements where appropriate (i.e.– compressor on/off, etc.).